AVR Premium Glaze Body Filler – Power Glaze – Canadian Branded – 450 ml

Our #1 selling, high-quality, is the world’s best sanding polyester putty for use as a finishing coat over body filler, large panels, or small spot filling. Its unparalleled sanding qualities . Blue cream hardener included. Canadain Branded. AVR GLAZE Ultra is the world’s best sanding polyester putty for use as a finishing coat over body filler, large panels, or small spot filling. Its unparalleled sanding qualities. Its unique thinner viscosity makes it ideally suited for intermixing with other filler products to improve flow out. Formulated for improved adhesion. Meets 500-hour corrosion resistance (ASTM B117) APPROVED SUBSTRATES: ▪ Sanded Body Filler ▪ Steel ▪ Aluminum ▪ Fiberglass ▪ E-Coat ▪ Silicon Bronze Welds ▪ Sanded OEM Paint ▪ Galvanized Steel ▪ SMC ▪ Stainless Steel ▪ Cured sanded 2K primer ▪ Rigid to Semi-Rigid Thermoset Plastics PREPARATION: Clean and degrease the entire panel to be repaired with soap and water, followed by a mild cleaning solvent. Thoroughly dry the surface before repairing. Use 80-180 grit to remove or scuff the paint and featheredge. MIXING: Place the desired amount of material on a clean, non-fibrous surface. Knead the cream hardener before use. Measure hardener 2% by weight by adding a ribbon of cream hardener from edge to edge across the center of a 4” (10 cm) diameter puddle. Puddles larger than 4” in diameter will require additional hardener. Mix thoroughly until uniform color is achieved. Approximate setting time is 2.5 – 4.5 minutes @ 72°F (22°C) APPLICATION: Spread a thin layer of mixed material over surface using firm pressure. Apply additional layers to build material slightly higher than the surface to allow for sanding to desired contour. NOTE: Do not apply over new or uncured coatings. Avoid thick heavy applications. FINISH: Sand to contour with 180 grit sandpaper. Final sand with 180 grit followed by 220-320 grit if desired. TOPCOAT: Apply 2K polyester, 2K urethane, 2K epoxy, or 1K primer to manufacturer’s recommendations.